chuck tender steak
intro
Juicy, deeply flavorful chuck tender steak with a crisp golden crust, basted in garlic herb butter, delivers restaurant-quality taste at a fraction of the cost of premium steak cuts.
Ingredients
Steps
Pat Steak Dry
Remove the 680g chuck tender steak from packaging 30 minutes before cooking to bring it to room temperature (this ensures even cooking). Place it on the acacia wood cutting board. Use paper towels to thoroughly pat every surface of the steak completely dry—there should be no visible surface moisture, as this is critical for a crisp sear. Trim any thick, tough silver skin from the steak surface using the chef knife, leaving thin flecks of marbling intact.
Season Steak Evenly
Sprinkle 1.5 tsp kosher salt and 1 tsp freshly ground black pepper evenly across all sides of the dried steak, including the edges. Press the seasoning gently into the meat surface with your fingertips so it adheres, rather than falling off during searing. Do not add flaky sea salt at this stage—it will burn during high-heat cooking.
Heat Skillet Properly
Place the 12-inch seasoned carbon steel skillet on the induction stovetop burner (center back of counter) over medium-high heat. Add 1 tbsp extra-virgin olive oil, and heat until the oil shimmers and just begins to send up a thin wisp of smoke—this takes approximately 3 minutes. Do not add the steak before the pan is fully hot, as this will cause sticking and a pale, weak crust.
Sear All Steak Surfaces
Use the stainless steel tongs to carefully lay the seasoned steak in the hot skillet, laying it away from you to avoid oil splatter. Sear for 2 minutes on the first side, until a deep, golden-brown crisp crust forms. Flip the steak, and sear the second side for another 2 minutes. Stand the steak on its edge with the tongs, and sear all 4 side edges for 30 seconds each, until every surface is evenly crusted. Total searing time is approximately 6 minutes.
Baste with Garlic Butter
Reduce stovetop heat to medium-low to prevent butter burning. Add the 4 tbsp unsalted butter, 4 crushed whole garlic cloves, 3 thyme sprigs, and 1 rosemary sprig to the skillet next to the steak. Once the butter melts and forms a light golden foam (about 30 seconds, no brown burnt specks), tilt the pan slightly toward you so the butter pools in the front lower edge. Use the stainless steel basting spoon to continuously ladle the hot, fragrant butter over the top of the steak for 3 full minutes, basting every surface.
Verify Internal Temperature
Pause basting to insert the instant-read meat thermometer horizontally into the very center of the thickest part of the steak, taking care not to touch fat deposits or the hot pan surface. Confirm the temperature reads 130°F (54°C) for medium-rare; if it reads lower, continue basting for 60-second intervals before rechecking. Do not cook the steak past 135°F (57°C) at this stage, as carryover cooking will raise the temperature 5°F as it rests, and chuck tender will turn tough if cooked past medium doneness.
Rest Cooked Steak
Use the stainless steel tongs to carefully lift the cooked steak from the skillet, letting excess butter drip back into the pan, and transfer it to the top oat beige stoneware plate (pulled from the back-right stack to the center counter). Loosely tent a small sheet of aluminum foil over the top of the steak (do not wrap it tightly, as this will steam the crust) and let it rest for 8 full minutes. Resting allows tight muscle fibers to relax and reabsorb juices, preventing all the flavorful juice from running out when the steak is sliced.
Slice Against the Grain
After the 8-minute rest, lift the foil tent off the steak. Move the acacia wood cutting board back to the center counter, and transfer the rested steak to the board. Identify the direction of the meat grain (the long, parallel lines of muscle fiber running lengthwise down the steak). Use the chef knife to slice the steak into uniform 1/2-inch thick slices, cutting directly perpendicular (across) the grain to shorten long muscle fibers for the most tender bite. Drizzle 1 tablespoon of the reserved warm herb butter from the skillet over the top of the sliced meat before arranging on the serving plate.
Tips
2.Do not cook chuck tender past medium-rare (135°F internal temp before resting): this cut comes from the heavily worked shoulder area, so it has longer, firmer muscle fibers that turn tough and chewy when cooked to well-done, unlike fattier premium cuts like ribeye.
3.Save the herb and garlic infused butter left in the skillet after cooking: toss it with roasted baby potatoes or sautéed green beans for a quick, flavorful side dish that uses every bit of flavor from the pan, no extra seasoning needed.

OMG, this was a total game changer for weeknight dinners! I always thought chuck tender was too tough for a quick steak night, but that garlic herb butter baste? *Chef’s kiss* My kids devoured it, even my picky 8 year old asked for seconds. Cooked it exactly 20 minutes total like the recipe said, came out perfect medium rare. 10/10 will make again for our next family dinner!
Wait, hold on—chuck tender for steak? I usually only use that for pot roasts, so I was super skeptical. Tried this last night and holy cow, it was SO good. Way cheaper than ribeye, and that garlic thyme butter made the whole house smell amazing for hours. Only note: I didn’t have fresh rosemary so I used dried, still turned out great.
Added this to my weekly meal prep rotation! Cooked up three of these on Sunday, sliced them thin, and they’ve been perfect for steak salads, wraps, and quick grain bowls all week. The herb butter gives it so much flavor I don’t even need extra dressing. Total win for busy work weeks.
Okay full transparency, I’ve never successfully cooked a steak that didn’t turn out tough or overdone before this. The recipe says medium difficulty and I was nervous, but the step by step for basting was so easy to follow! I did accidentally burn the garlic a tiny bit my first go, but it still tasted incredible. My husband thought I ordered takeout from a steakhouse lmao
Made this for our neighborhood block party potluck last weekend and people were asking me for the recipe before I even finished serving! I sliced it up thin against the grain like the recipe said, set it out with some horseradish sauce, and it was gone in 10 minutes. Only downside: I wish I’d made twice as much!
Taste was great, but I struggled a little with the cook time? My steak was about 1.5 inches thick, and 20 minutes total had it closer to well done than the medium rare I wanted. Flavor of the garlic herb butter was chef’s kiss though, just had to adjust the time for my stove which runs hot.
If you love garlic, run don’t walk to make this. I added an extra three cloves (no such thing as too much garlic tbh) and used salted butter because that’s what I had, and it was absolute perfection. Served it with roasted asparagus and mashed cauliflower for a low carb date night in, 10/10.
As a broke college student who’s sick of ramen and frozen pizza, this was such a win! Chuck tender is like half the price of other steaks at my grocery store, and I already had most of the herbs and butter in my fridge. Took me a little longer than 20 minutes because I was going slow to not mess it up, but it was worth every second.
I was convinced basting with butter was just fancy chef nonsense that didn’t actually make a difference, but my partner begged me to try this recipe so I caved. Wow, I was so wrong. The butter soaks into every little crevice, the herbs get all fragrant, it’s way better than just grilling a plain steak. Eating my words (and a whole lot of steak) right now.
So happy to find a naturally gluten free steak recipe that doesn’t require weird specialty ingredients! I have celiac so I’m always paranoid about hidden gluten in seasonings, but this is just simple herbs, butter, garlic, salt and pepper. Served it with roasted potatoes for my whole family, everyone loved it, no cross contamination scares. Win win.
20 minute cook time? Sign me up. I get home at 6 every night and have zero energy for hour long recipes, and this was on the table by 6:30 including the side salad. The only miss for me was that my herb butter separated a little? Not sure if I had the pan too hot or what, but the flavor was still off the charts.
Usually I smoke all my meats low and slow, but it was 95 degrees out last weekend and I didn’t want to stand by the smoker for hours. Gave this stovetop method a shot and I was shocked how juicy it came out! Added a little smoked salt to the herb butter to get that smoky flavor I love without firing up the smoker, 10/10 will make this on hot summer weeknights for sure.
Y’all, the leftover steak from this made the BEST breakfast steak and eggs the next morning. I was worried it would dry out when I reheated it (I did low power in the microwave with a damp paper towel) but it was just as juicy as night one. Who knew a cheap chuck steak could be so versatile?
Really solid base recipe! I kicked it up a notch by adding a pinch of red pepper flakes and a splash of Worcestershire to the garlic herb butter, and it gave it the perfect little zing. If you like a little heat, highly recommend that add-in. Paired it with garlic bread to soak up all that extra butter, no regrets.
This fits perfectly into my high protein meal plan! Each serving is like 35g of protein, super low carb if you skip the sides I guess, and way more flavorful than plain grilled chicken that I eat 5 days a week. The butter adds just enough fat to keep me full through my evening workouts, no mid-session energy crashes. Will be on repeat.
Made this for my anniversary dinner with my partner last night, and they said it was better than the $60 steak we got at the fancy downtown restaurant for our last anniversary. For real, that garlic herb butter is so luxurious you’d never guess this is a budget cut of beef. Served it with truffle mashed potatoes and roasted Brussels sprouts, total romantic dinner win without the crazy price tag.