beef chicken steak
intro
Juicy, pan-seared beef sirloin and tender chicken breast steaks with crisp golden crusts, finished with fragrant garlic herb butter for a satisfying, restaurant-quality weeknight meal.
Ingredients
Steps
Pat and Season Meats
Place beef sirloin medallions and evenly pounded chicken breasts on the walnut cutting board. Pat all surfaces of both meats completely dry with a clean section of the linen towel to eliminate excess surface moisture (critical for a crisp, deep sear). Season every side of the beef and chicken with 1.5 tsp flaky sea salt and 1 tsp freshly cracked black pepper, pressing seasoning gently into the meat to help it adhere. Let seasoned meats rest at room temperature for 10 minutes to take the chill off and allow salt to penetrate.
Preheat the Skillet
Place the 12-inch seasoned carbon steel skillet on the center-right counter over medium-high heat, add 1 tablespoon of olive oil, and heat until the oil shimmers and just begins to send up faint wisps of smoke, approximately 3 minutes. Do not add butter at this stage, as it will burn at this high searing temperature.
Sear Beef Steaks
Use the stainless steel tongs to carefully lay the beef sirloin medallions in the hot skillet, laying them away from your body to prevent hot oil splatters. Sear undisturbed for 3 minutes on the first side, until a deep mahogany-brown crust forms across the entire contact surface. Flip steaks with tongs, sear the second side for 2–3 minutes, until internal temperature reaches 135°F (57°C) for medium-rare (add 1 minute per side for medium, 2 minutes for well-done). Transfer seared beef to a sheet of aluminum foil set to the side of the skillet, and tent loosely to rest.
Sear Chicken Breasts
Without wiping out the skillet, reduce heat to medium. Use tongs to place the seasoned chicken breasts in the same hot pan, using rendered beef fat and remaining oil to cook them. Sear undisturbed for 4 minutes on the first side, until the crust is deep golden and crisp. Flip the chicken, and cook for another 3–4 minutes on the second side, until internal temperature reaches 165°F (74°C) with no pink remaining in the thickest part. Transfer seared chicken to the foil with the resting beef, and tent loosely to keep warm.
Sauté Garlic and Herbs
Reduce heat under the skillet to medium-low. Add 4 tablespoons of unsalted butter, crushed garlic cloves, rosemary, thyme, and thinly sliced yellow onion to the remaining pan drippings. Sauté for 2 minutes, stirring gently with the wooden spoon, until the garlic is soft and fragrant (do not let it turn dark brown, as it will become bitter) and the onion softens into light golden strands, creating a fragrant herb-infused butter sauce.
Slice Rested Meats
After the meats have rested for 5 full minutes (to allow juices to redistribute), transfer the beef and chicken from the foil back to the walnut cutting board, pouring any collected juices from the foil into the skillet with the herb butter. Use the chef knife to slice the beef against the grain into 1cm thick slices, and slice the chicken breast on a slight diagonal into 1.5cm thick slices.
Arrange on Plate
Retrieve the matte cream ceramic dinner plate from its stored position at the top right of the counter. Fan the sliced beef across the left half of the plate, and fan the sliced chicken across the right half, leaving a small gap between the two meats for garnish.
Finish with Butter
Stir the collected meat juices into the herb butter sauce to combine, then use a spoon to drizzle the warm sauce and caramelized onion strands evenly over the top of both sliced meats. Tuck a small fresh rosemary sprig between the beef and chicken for garnish, and serve immediately while warm.
Tips
2.Let seared meat rest for 5 full minutes before slicing: this allows tight, heated muscle fibers to relax and reabsorb juices, so every bite stays juicy instead of having all liquid run out onto the plate when cut.
3.Resist the urge to move or prod meat while it sears: flipping too often prevents the deep, even golden crust from forming. Only flip each cut once per side to build maximum flavor and texture.

OMG this pan-seared steak combo was a total game changer for our Sunday family dinner! I was worried cooking both beef and chicken at the same time would be a mess, but the 20 minute cook time is no joke. My 8 year old asked for seconds of the chicken, my husband raved about the beef crust. 10/10 will add to our weekly rotation!
Made this for my weekly meal prep and it held up so good! I seasoned the beef and chicken the night before to cut down on cook time, then seared everything while my roasted veggies were in the oven. Way better than the sad takeout I usually grab for work lunches. Only tweak: I added a little extra garlic powder because I’m a total garlic fiend, zero regrets.
Took this to a neighborhood potluck last weekend and people were hounding me for the recipe! The only issue I had was my chicken came out a tiny bit dry — I think I left it on the pan a minute too long because I was distracted by guests. Still tasty though, will watch the timer closer next time!
Was skeptical pan-seared could beat my usual outdoor grill method for steaks, but rainy weather forced me inside and wow. That crust? Unreal. My teen who only eats chicken nuggets even tried a bite of the beef and said it wasn’t “that bad” which is basically a 5 star review from him lmao
As someone who’s solidly medium skill level in the kitchen (read: I burn toast at least half the time) this recipe was so doable! The instructions were super clear, no weird fancy ingredients required. I served it with mashed potatoes and roasted broccoli, and my roommate thought I ordered fancy takeout lmao. SO good, will be making this again soon.
Wait has anyone tried making this with thinner cut steaks? I grabbed some super thin sirloin and thin chicken cutlets on sale at the grocery store and I don’t want to overcook them! The recipe says 3-4 minutes per side for thicker cuts, so I’m guessing less time for thin ones?