beef short ribs pellet grill
intro
Tender, smoky beef short ribs with a rich mahogany bark, slow-smoked on a pellet grill for melt-in-your-mouth texture and deep, wood-fired Texas BBQ flavor.
Ingredients
Steps
Trim Rib Fat Cap
Place the 4lb short rib slab bone-side down on the maple cutting board. Use the 6-inch boning knife to trim the thick top fat cap down to a uniform 1/4-inch thickness, removing any hard, waxy fat chunks and all papery silver skin from the meat surface. Trim any loose, thin meat flaps that will burn during long smoking. The finished meat surface should feel smooth when you run a clean hand across it, with no ragged edges.
Mix Dry Rub
Combine 2 tbsp coarse kosher salt, 2 tbsp freshly cracked black pepper, 1 tbsp garlic powder, 1 tsp smoked paprika, and 1 tsp onion powder in the brushed stainless steel mixing bowl. Stir the spices with the tip of the chef’s knife until fully blended, breaking up any small clumps of paprika or garlic powder to create a uniform, speckled rub mixture.
Apply Dry Rub
Pat every surface of the trimmed short rib slab completely dry using the indigo cotton kitchen towel. Sprinkle the dry rub generously over the top, bottom, sides, and gaps between the bones, pressing the rub firmly into the meat with a clean palm to create a uniform, adherent coating. Let the seasoned ribs rest at room temperature for 20 minutes while the pellet grill preheats, allowing salt to draw out surface moisture that will form the base of the dark bark.
Preheat Pellet Grill
Fill the pellet grill hopper with oak or hickory hardwood pellets, then preheat the grill to a steady 225°F (107°C). Wait until the grill produces thin, wispy blue smoke (not thick, billowing white smoke, which causes bitter flavor) before adding meat. Place an empty metal drip pan under the grill grates in the position where the ribs will cook, to catch rendered fat and prevent flare-ups.
Smoke Ribs Low
Use the stainless steel tongs to place the seasoned short rib slab bone-side down directly on the preheated grill grates, positioned away from the direct heat of the fire pot. Close the grill lid and maintain a consistent 225°F temperature for the first 3 hours of cooking, avoiding unnecessary lid lifts which cause large temperature drops. After the first 3 hours, spritz the ribs lightly with apple juice every 45 minutes to keep the meat surface moist and encourage dark bark formation.
Wrap Ribs Tightly
When the ribs reach an internal temperature of 165°F (74°C), measured with the digital instant-read thermometer (approximately 3.5 to 4 hours into cooking), use the tongs to transfer the ribs to a double layer of uncoated butcher paper laid across the maple cutting board. Wrap the ribs tightly, folding all paper edges to seal in steam, then return the wrapped ribs to the grill bone-side down. Maintain the 225°F cooking temperature.
Test Rib Doneness
After 2 to 2.5 hours of wrapped cooking, begin checking for doneness with the digital thermometer. The ribs are fully cooked when the probe slides into the thickest part of the meat with zero resistance, like sliding a warm knife into soft butter, at an internal temperature of 203°F (95°C). Visual confirmation: the meat will have pulled back 1/4 to 1/2 inch from the cut ends of the rib bones.
Rest the Ribs
Once the ribs reach target temperature, transfer the tightly re-wrapped ribs to the front edge of the counter, and loosely tent with a sheet of aluminum foil. Let the ribs rest for 45 minutes to allow muscle fibers to relax and reabsorb rendered juices, rather than letting juices run out onto the plate when sliced. Do not skip this step, as it is critical for juicy, tender ribs.
Plate and Serve
Unwrap the rested ribs, slice between the bones to create individual 1-bone portions. Arrange the ribs on the terracotta dinner plate, sprinkle lightly with a pinch of flaky salt and scatter a few fresh thyme leaves across the top for garnish. Serve immediately, with no heavy BBQ sauce needed to let the deep smoky beef flavor take center stage.
Tips
2.Wait for thin, blue, almost invisible smoke before putting ribs on the grill: thick white smoke from incompletely ignited pellets leaves a bitter, ashy coating on the rib bark, instead of the smooth, sweet wood smoke flavor that defines great Texas BBQ.
3.Never wrap ribs in aluminum foil for the tender finish stage: foil traps too much moisture and will turn your crisp, dark bark soft and mushy, while uncoated butcher paper allows a small amount of steam to escape, keeping bark intact while tenderizing the meat.

OMG these were the star of our Sunday family dinner last weekend! I was nervous about nailing fall-off-the-bone texture on my new pellet grill, but following the timing exactly worked perfectly. My husband said they’re better than the ribs at our favorite local BBQ joint, and my kids practically licked the bones clean. SO good, will be making these for every fall potluck from now on!
Quick question—this is only my third time using my pellet grill, do I really need to spritz them every hour like the recipe says? I’m worried I’ll let too much heat out opening the lid that much.
Made a big batch of these for meal prep this week and they reheated like a dream! I shredded the leftover meat to put in tacos and top baked potatoes, and it held up all 5 days in the fridge. Total game changer for easy weeknight meals when I don’t have time to cook after work.
Took these to our neighborhood block party last Saturday and people were lined up for seconds. I used a hickory pellet blend instead of the suggested mesquite because that’s what I had on hand, and it was chef’s kiss. Only note is I had to add 20 extra minutes of cook time because it was a little chilly outside here, so folks with colder weather should plan for that!
Wait, has anyone tried making these with a dry rub that’s a little less spicy? My kids can’t handle too much black pepper or cayenne, and I don’t want to mess up the texture by changing the rub too much.
5.5 hours was exactly spot on for my 3.5lb rack of ribs. I’ve tried so many short rib recipes that come out tough or chewy, but this one delivered exactly what it promised—straight fall off the bone, no fighting to get the meat off. The bark was perfect too, not too thick, not too thin.
I know this is a short rib recipe but I tested the method on beef back ribs first out of habit and it worked insanely well? 10/10, will be making the actual short rib version this coming weekend when my brother comes to visit from out of state.
Help! I followed the recipe exactly but my ribs came out a little tougher than I expected? I checked the temp and it hit 203 like the guide said, but they didn’t pull clean from the bone. Did I do something wrong?
Made these for the first football watch party of the season and my friends refused to order wings for the rest of the season. Zero leftovers, zero complaints. Worth every minute of the 5.5 hour cook time, even if I had to wake up early to get them done before kickoff.
So happy this recipe is naturally gluten free! I didn’t have to swap a single thing to make it work for my celiac diet, and no one at the dinner party I brought them to even noticed they were GF. The flavor is that good, no weird specialty ingredients required.
Question for folks who’ve made this—beef short ribs can be so pricey where I live. Has anyone tried this method with boneless short ribs to cut down on cost? I don’t want to waste money if it won’t turn out right.
SO good. Made these last night, ate half the rack standing over the kitchen counter before I even remembered to make sides. No regrets. 10/10.
This recipe is why fall is my favorite cooking season! The smell of these ribs smoking on the pellet grill while the leaves are falling outside? Pure cozy perfection. I served them with roasted garlic mashed potatoes and apple cider coleslaw, chef’s kiss combo.