Peppermint Bark Fudge
intro
Creamy two-layer dark and white chocolate fudge swirled with crisp peppermint candy, a cool, festive no-bake treat perfect for holiday gifting and Christmas gatherings.
Ingredients
Steps
Line Baking Dish
Fit the cut unbleached parchment paper into the 20cm square matte light gray ceramic baking dish, pressing it flat against the bottom and sides so the 5cm overhang tabs extend evenly over the two long sides. Lightly coat the parchment with a thin swipe of butter (taken from the measured 4 tbsp) to prevent sticking, and set the dish at the center of the counter in front of the induction cooktop.
Crush Candy Canes
Place all 12 unwrapped candy canes inside the 1L clear resealable zip-top bag, pressing out excess air and sealing the bag tightly. Use the light honey-toned maple rolling pin to gently tap and roll over the bag, crushing the candy canes into a mix of coarse 5mm chunks and fine peppermint dust. Set aside 1/4 cup of the crushed candy for topping, and divide the remainder equally between the two small clear glass ramekins.
Melt Dark Chocolate Base
Fill the 1.5L stainless steel saucepan with 5cm of water, and set it on the matte black induction cooktop to bring to a gentle simmer over low heat (no rolling boil, to avoid seizing chocolate). Place the medium brushed stainless steel mixing bowl on top of the saucepan to form a double boiler, ensuring the bowl bottom does not touch the water. Add 2 tbsp of the cut butter, half the can of sweetened condensed milk (198g), all the dark chocolate chips, and 1/8 tsp of fine sea salt to the bowl. Stir continuously with the red-handled silicone spatula for 3-4 minutes, until the mixture is completely smooth, glossy, and free of lumps. Remove the bowl from the heat immediately once melted.
Set Dark Chocolate Layer
Immediately pour the fully melted dark chocolate mixture into the parchment-lined baking dish, using the silicone spatula to spread it into an even, smooth layer across the entire bottom of the dish. Sprinkle one ramekin of crushed peppermint (the non-reserved portion) evenly over the dark chocolate, then transfer the dish to the refrigerator to chill for 15 minutes, until the surface is firm to the touch and no longer sticky when pressed lightly with a clean finger.
Melt White Chocolate Layer
While the dark layer chills, wipe out the medium stainless steel mixing bowl with a paper towel, and return it to the double boiler over gently simmering water. Add the remaining 2 tbsp butter, remaining half of the sweetened condensed milk, all the white chocolate chips, remaining 1/8 tsp sea salt, and 1 tsp pure peppermint extract to the bowl. Stir continuously with the silicone spatula for 2-3 minutes, until the mixture is completely smooth, thick, and free of lumps. Remove from heat and let cool for 5 minutes, so it does not melt the chilled dark chocolate layer when poured.
Add White Chocolate Layer
Remove the baking dish with the chilled dark chocolate layer from the refrigerator. Pour the cooled white chocolate fudge mixture evenly over the top of the firm dark chocolate layer, using the silicone spatula to spread it into a smooth, even layer that covers the dark chocolate completely. Tap the dish gently on the counter 2-3 times to release any trapped air bubbles and create a perfectly level surface.
Add Peppermint Topping
Immediately sprinkle the reserved 1/4 cup of crushed peppermint candy evenly across the top of the warm white chocolate layer, pressing very gently with the flat side of the spatula to make sure the candy pieces adhere to the fudge and do not fall off when cut. Do not press hard enough to push the candy fully into the fudge layer.
Chill and Slice Fudge
Transfer the assembled fudge back to the refrigerator to chill for a full 2 hours, until completely firm all the way through when pressed in the center (no soft give). Once set, lift the fudge out of the baking dish using the parchment paper overhang tabs, and set it on the clean counter surface. Use the 20cm chef’s knife to cut the fudge into 24 even 3cm square pieces, wiping the knife blade clean with the cream linen towel between cuts for sharp, clean edges.
Tips
2.Let the melted white chocolate mixture cool for 5 full minutes before pouring it over the chilled dark chocolate layer. If the white chocolate is too hot, it will melt the dark chocolate below, creating muddled, uneven layers instead of the classic distinct peppermint bark stripes.
3.For the cleanest cuts, run the chef’s knife under hot tap water and wipe it dry between every slice. A warm blade glides through cold fudge without cracking the peppermint top or dragging chocolate across cut edges, giving you professional, neat square pieces.

OMG this peppermint bark fudge is SO good! I whipped this up last night for my office holiday potluck and everyone was begging for the recipe. Only took 10 minutes like the recipe said, total game changer for when you forget you signed up to bring a treat last minute. I crushed up extra candy canes on top for more crunch, 10/10 would make again.
Made this with my 8 year old over the weekend for our extended family Christmas dinner, and my kids loved it! It was easy enough that he could help stir and sprinkle the peppermint bits without me stressing about a huge messy kitchen. Only knock is I wish it made a little more — my husband ate half the pan before we even left for dinner lmao
I’m absolutely terrible at baking and I was so nervous to make treats for my neighborhood gift drop off this year, but this peppermint bark fudge was so easy! The 10 minute cook time is no joke, I swear I spent longer picking out which candy canes to use at the grocery store than I did making the actual fudge. Tastes exactly like the fancy peppermint bark they sell at the mall for $20 a tin, will be adding this to my annual holiday rotation for sure.