pulled pork weber kettle
intro
Fall-apart tender, smoky pulled pork cooked low and slow on a classic Weber kettle, with a crispy mahogany bark, subtle smoke ring, and juicy shreds perfect for piling high on sandwiches.
Ingredients
Steps
Trim Pork Shoulder
Place the 4lb bone-in pork shoulder on the acacia wood cutting board. Use the 6-inch boning knife to trim the thick fat cap to a uniform 1/4-inch thickness, removing any hard, waxy fat deposits and loose silver skin from the meat surface. Leave a thin, even fat layer to keep the meat moist during smoking; the surface should feel smooth with no ragged edges when you run a clean hand across it.
Coat with Spice Rub
Spread a thin, even layer of yellow mustard across all surfaces of the trimmed pork shoulder to act as a rub binder. In the 1-quart stainless steel mixing bowl, combine kosher salt, black pepper, smoked paprika, garlic powder, brown sugar, and dry mustard powder, stirring to mix evenly. Generously sprinkle the rub over every side of the pork, pressing gently to adhere so no bare meat is visible. Let the rubbed pork rest at room temperature for 15 minutes while you prep the grill.
Set Up Weber Kettle
Remove the cooking grate from the 22-inch Weber kettle. Light 1 chimney starter full of natural lump charcoal, waiting until coals are covered in a thin layer of gray ash (approximately 15 minutes). Pour the lit coals into a single pile on one side of the kettle’s charcoal grate to create an indirect two-zone cooking setup, placing 2 hickory wood chunks directly on top of the lit coals. Set the 9x13 inch aluminum drip pan on the empty side of the charcoal grate, filling it halfway with tap water to regulate temperature and catch drippings. Replace the cooking grate, adjusting the top and bottom vents to bring the grill temperature to a steady 225°F, measured at grate level.
Smoke Pork Indirectly
Use the long-handled BBQ tongs to place the rubbed pork shoulder on the cooking grate directly above the water-filled drip pan, fat side up, away from the direct heat of the coals. Close the kettle lid, maintaining a steady 225-250°F temperature for the duration of the cook, adding 1 fresh hickory chunk and 5-6 pieces of unlit lump charcoal every 90 minutes to maintain consistent heat and smoke. Spritz the pork surface with apple cider vinegar from the clear spray bottle every hour after the first 2 hours of cooking to keep the bark moist. Avoid opening the lid unnecessarily to prevent temperature drops.
Check Internal Temp
After 6 hours of cooking, insert the digital instant-read meat thermometer into the thickest part of the pork shoulder, avoiding contact with the bone. The pork is ready to wrap when the internal temperature reaches 165°F, and the exterior has formed a dark, matte mahogany bark that is dry to the touch. If the bark looks pale or wet, continue cooking unwrapped for another 30 minutes before checking again.
Wrap and Rest Pork
Use the BBQ tongs to transfer the 165°F pork from the grill to a double layer of heavy-duty aluminum foil laid out on the acacia cutting board. Wrap the pork tightly, sealing all edges to trap steam, then return it to the indirect heat side of the kettle. Continue cooking until the internal temperature reaches 203°F, when the probe slides into the meat with no resistance (like sticking a knife into soft butter, approximately 1 to 1.5 additional hours). Remove the wrapped pork from the grill, and let it rest on the counter for a full 1 hour, still tightly wrapped, to allow juices to redistribute.
Pull Tender Pork
Unwrap the rested pork, pouring off any collected rendered fat and juice from the foil (reserve 2 tablespoons of juice to mix into the pulled pork if desired). Use two forks to shred the pork into bite-sized strands, discarding the shoulder bone and any large remaining chunks of hard fat. Mix the shredded pork lightly to distribute the dark bark pieces evenly throughout the tender, juicy meat, then pile onto the matte cream stoneware plate for serving, paired with vinegar-based BBQ sauce in the clear glass ramekin.
Tips
2.Never skip the 1-hour wrapped rest after cooking: as the pork holds temperature in the foil, tight muscle fibers relax and reabsorb trapped juices, instead of letting those juices run out onto your cutting board the moment you shred the meat, resulting in juicier pulled pork even without extra sauce.
3.Resist the urge to open the kettle lid frequently or crank vents to speed up cooking: temperatures above 275°F will cause the pork’s collagen to seize up instead of breaking down into tender gelatin, leading to tough, dry pulled pork even if you reach the 203°F target internal temperature.

OMG this pulled pork was a total game changer for our weekend cookout! I’ve always been nervous to do low-and-slow on my old Weber kettle because I thought I’d mess up the temp control, but the step-by-step for the charcoal snake method worked perfectly. 7.5 hours felt long but it was so worth it — the pork was fall-apart tender, my kids devoured two sliders each before I even got the sides out. Will 100% be making this for our 4th of July potluck next month!
First time attempting pulled pork ever, super excited to try this this weekend! Quick question — I don’t have apple wood chips, would hickory work as a swap? Also, do I need to spritz the pork the whole time, or can I get away with skipping that step if I’m running in and out with my dog? 😂
Made this yesterday for Sunday dinner and the flavor was unreal, but my temp spiked up to 300 for about an hour halfway through because the wind picked up. The pork was still good but a little drier than I wanted on the ends. Any tips for shielding the kettle from random wind gusts next time?
SO good!!! I made a big batch of this on Sunday and portioned it out for lunches all week, tossed a little of it with BBQ sauce on salads, in wraps, even mixed into mac and cheese for a quick dinner one night. The bark was perfectly crispy, the meat had just the right amount of smoke, and it reheated like a dream without getting all rubbery. Total meal prep staple for me now!
Y’all, I brought this pulled pork to my neighborhood block party last weekend and people were literally coming up to me asking for the recipe before they even finished their first sandwich. I used the exact charcoal snake setup laid out here and the temp held steady the entire 7.5 hours, no fiddling required. Game. Changer.
I just got my first Weber kettle last month and was so intimidated by low-and-slow cooks, I thought for sure I’d burn the whole thing to a crisp. This recipe broke every step down so simply, even I could pull it off! The pork was so juicy I didn’t even need that much sauce, my roommate said it was better than the BBQ joint down the street.
Loved this recipe! Only question — my grocery store was out of bone-in pork shoulder, so I grabbed a 6lb boneless one instead. Should I adjust the cook time for that, or keep it the same 7.5 hours?
Tried this over the weekend and added a little extra brown sugar and paprika to my dry rub, plus a splash of apple cider vinegar in my water pan, and oh my GOD it was so good. My dad has been making pulled pork on his Weber for 30 years and he said this was the best he’s ever had. Who’s winning the family cookoff now? 😎